Quick Links - Also see the menu above and more choices on the right side of the blog (too much, but all good stuff)

\/ ...and now BIMbuilder.com Blog Posts... \/

Wednesday, September 30, 2009

Revit® MEP 2010—English Update 2 Just Released [Updates] (20090917_1515)

IMPORTANT

This download is the latest update for Autodesk® Revit® MEP 2010 software as part of the AutoCAD® Revit® MEP Suite 2010 software.
It is available to users who have purchased a valid license for AutoCAD Revit MEP Suite 2010 software, and is subject to the terms and conditions of the end-user license agreement that appears during installation.
For a list of improvements, please download the Autodesk® Revit® MEP 2010 Update Enhancement List:

Update Enhancement List (pdf - 249Kb)
Note: Build Number can be found in the Update Enhancement List
Update 2 – September 2009
Important Note:
Update 2 is not a full install; rather it is using service pack technology similar to AutoCAD® based products. Prior to installing the Update 2, please verify that you have already installed the First Customer Ship build of Autodesk Revit MEP 2010 which is available below.
Before You Download
Please read before downloading and installing:

Service Pack Readme (htm - 52Kb)
Get Started
Read all instructions above then click the following link to download.
Autodesk Revit MEP 2010 Update 2_32-bit (exe – 68.0 Mb)
Autodesk Revit MEP 2010 Update 2_64-bit (exe – 94.1 Mb)
Note:
  • The service pack contains changes from the previous service pack (Update 1 - June 2009).
  • The service pack can be applied to both the standalone and suite versions of Autodesk Revit MEP 2010.
Improvements made in Update 2 build (20090917_1515):

Autodesk® Revit® MEP 2010 Enhancements
 Wire length in the Circuit Properties dialog will now display “Not Computed” for the wire length when a
panel has not yet been assigned to a circuit.
 The calculation of complex space volumes for heating and cooling loads has been improved.
 Panel and circuit information can now be displayed in a mechanical equipment schedule.
 Improved the ability to swap one type of pipe or duct accessory for another type of pipe or duct
accessory.
 When use of the Split tool on a duct segment creates a union, the union is no longer automatically
deleted when a new duct is connected to the union.
 Improvement of a duct segment centerline alignment when rotated in an elevation view.
 Windows and doors set as demolished will no longer appear in a gbXml export.
 Improved stability when copying elements from one family to another in the Family Editor.
 When the Create Similar tool is used for a sloped pipe, the slope is now properly maintained for the
new pipe.

Autodesk - Autodesk Revit MEP Services & Support - Autodesk® Revit® MEP 2010—English


0 comments:

  © Blogger template ProBlogger Template by Ourblogtemplates.com 2008

Back to TOP  

[Valid Atom 1.0]