Quick Links - Also see the menu above and more choices on the right side of the blog (too much, but all good stuff)

\/ ...and now BIMbuilder.com Blog Posts... \/

Tuesday, April 13, 2010

Revit Structure Services & Support - Error: Slab shape edit failed when setting the curved edge condition

Wouldn't it be great if you actually had the software loaded so you could have the chance to run into these issues? I hope it gets released soon. Too bad we all have no idea the actual ship date. I just keep guessing, just like you.
Published date: 2010-Apr-13
ID: TS14988849
Applies to:
Autodesk® Revit® Structure 2011
Autodesk® Revit® Structure 2010

Issue

You have set the Curved Edge Condition of a shape edited slab to Project to Side, and you received an error that the Slab Shape Edit failed.

Solution

This may occur with the following conditions:
  1. Your slab has a curved edge.
  2. You used the Pick Supports tool in the Slab Shape Edit mode.
  3. You then adjusted the Curved Edge Condition.
This message occurs when attempting to adjust the Curved Edge Condition if user drawn edge falls outside of the perimeter of the slab. In your model, look for a scenario similar to the one shown below:

To work around the issue, delete or adjust the offending curve so the scenario does not occur.
Autodesk - Autodesk Revit Structure Services & Support - Error: Slab shape edit failed when setting the curved edge condition


0 comments:

  © Blogger template ProBlogger Template by Ourblogtemplates.com 2008

Back to TOP  

[Valid Atom 1.0]